Basic steps – Juniper Networks IDP SERIES IDP250 User Manual
Page 34
Basic Steps
Take the following basic steps to install the appliance and connect it to your network:
1.
Read the release notes for your release. Release notes make you aware of supported
and unsupported features, known issues, and fixed issues. Go to
and download the
release notes for your release.
2.
Become familiar with the safety and security guidelines that pertain to your installation.
See
.
3.
Decide on the physical location for the appliance. The location depends on your
deployment mode, the location of your network devices, and compliance with your
company security policy.
4.
Install the appliance into your equipment rack. See Rack Mounting Kits and Required
Tools.
Although you can place the appliance on a desktop for operation, we do not
recommend deploying it in this manner.
5.
Connect power cables and power on. See Connecting Power.
6.
Perform the initial configuration steps. See
“Performing the Initial Configuration” on
.
7.
Install the appliance license key. See
“Installing the Product License Key” on page 31
NOTE:
In these steps, you are instructed to install the product license key
before you add the appliance to NSM. If you install the product license
key after you add the appliance to NSM, you must re-add the appliance
to NSM.
8.
Connect the appliance to your network. See
“Guidelines for Connecting IDP Interfaces
to Your Network Devices” on page 33
9.
Verify connectivity. See
“Verifying Traffic Flow” on page 36
.
10.
In NSM, add the IDP Series appliance to the NSM device manager. See
Reachable IDP Device to NSM” on page 41
11.
Upgrade the IDP software to the current release, update the IDP detector engine
firmware, and update the NSM attack object database. See
.
Copyright © 2012, Juniper Networks, Inc.
22
IDP250 Installation Guide