Juniper Networks IDP SERIES IDP250 - Manual (Page 37)

Mounting to Rack Rails
To mount the device to equipment rack rails:
1. Attach the rails to each side of the chassis with the bracket screws. Make sure the
hinged brackets are at the back of the device. Make sure the rails are positioned so
they reach the back of the rack when the device is mounted.
Figure 11: Rail with Hinged Rear Bracket
2. Rotate the hinges on both rails so that they allow the device to slide into the rack.
3. With another person, slide the chassis and rails into the rack.
CAUTION: Be sure to leave at least two inches of clearance on the sides
of each chassis for the cooling air inlet and exhaust ports.
4. Secure the front brackets to the rack.
5. Rotate the rear brackets so they prevent the device from sliding forward.
6. Secure the rear brackets to the rack.
Related
Documentation
Rack Mounting Kits and Required Tools •
Connecting Power
Power is provided to the appliance using 90/264 VAC from your facility.
To connect power:
1. Connect the power cable (provided) to the receptacle on the power supply at the rear
of each chassis.
2. Connect the other end of the power cable to the electrical outlet.
25 Copyright © 2012, Juniper Networks, Inc.
Chapter 4: Installing the Appliance to Your Equipment Rack and Connecting Power