Juniper Networks IDP SERIES IDP250 - Manual (Page 42)

7. Type an IP address and press Enter.
The following text appears:
What netmask do you want to configure for the management interface?
[255.255.255.0]
8. Type your netmask and press Enter.
The system configures your interfaces. The following text appears:
Configuring default route...
The current default route is: X.X.X.X
Do you want to change the default route? (y/n) [n]
9. Type Y and press Enter.
The following text appears:
What IP address do you want to configure as default route? [X.X.X.X]
10. Type your default route (gateway address) and press Enter.
The system asks if you want to change the system time.
Configuring system time...
Currently configured time is Wed Jan 18 16:32:32 PST 2006
Do you want to change the system time? (y/n) [n]
11. Type N if the time is correct. If the time is not correct, type Y and follow the prompts
to change the system time.
Configuration of the management port is now complete. EasyConfig does not run the
next time you log into the appliance.
Related
Documentation
Performing the Initial Configuration on page 27 •
Getting Started with the QuickStart Wizard (Management Port)
If you cannot connect to the serial port, you can run the QuickStart wizard from the
management port to assign an IP address to the management interface.
To get started with the QuickStart wizard:
1. Connect one end of an Ethernet cable to the management interface port and the
other end to the Ethernet port of your laptop.
2. On your laptop, open a Web browser.
3. In the browser Address or Location box, enter https://192.168.1.1.
NOTE: ACM access uses SSL, so you must type https:// and not http://.
4. Log in as the user root with the default password (abc123).
Copyright © 2012, Juniper Networks, Inc. 30
IDP250 Installation Guide