Juniper Networks IDP SERIES IDP250 - Manual (Page 40)

Table 13: Getting Started Configuration Tools
Defaults Applied: You Specify: Getting Started Tool
• Root password: abc123
• Fully qualified domain name: Blank
• RADIUS support: Disabled
• Network interfaces: Auto-negotiate
speed/duplex
• Virtual routers:
• Sniffer mode: One virtual router (vr0)
• Transparent mode: One virtual router for
each pair of interfaces
• NIC State: NICs off
• DNS: Disabled
• NTP: Disabled
• SSH on management port: Enabled
• Start the ACM process when the appliance
starts up: Enabled
• Management interface IP address and
netmask
• Default route
• Time zone, date, and time
• Deployment mode (sniffer or transparent)
for the default virtual router(s)
EasyConfig wizard
(Serial port)
Same as EasyConfig Wizard. Same as EasyConfig Wizard. QuickStart wizard
(Management port)
• Management interface IP address and
netmask
• Passwords for root and admin
• Fully qualified domain name
• Traffic interface configuration (speed/duplex,
NIC states, route table)
• Virtual routers: deployment mode (sniffer or
transparent) and NIC bypass (internal,
external, or NICs off)
• Peer port modulation
• Layer 2 bypass (pass-through)
• Network services (DNS, NTP, RADIUS, SSH)
• ACM access
• NSM connection information
• One-time password (OTP) for interoperability
with Juniper Networks SA Series or UAC
devices
ACM wizard
(Management port)
Related
Documentation
Getting Started with the EasyConfig Wizard (Serial Console Port) on page 29 •
• Getting Started with the QuickStart Wizard (Management Port) on page 30
• Getting Started with the ACM Wizard (Management Port) on page 31
Copyright © 2012, Juniper Networks, Inc. 28
IDP250 Installation Guide