Juniper Networks IDP SERIES IDP250 - Manual (Page 66)

5. Let go of the lever and slide out the power supply from the handle.
6. Let go of the handle and use both hands to slide the power supply the rest of the way
out.
To install a power supply:
1. Take the new power supply to the back of the device.
2. Hold the power supply with both hands with the red handle on the left side of the
power supply.
3. Align the power supply with the empty bay and slide the power supply into the bay.
4. Push firmly until you see and hear the red lever snap into place.
If the other power supply is on and powering the appliance, the appliance emits a
high-pitched whine and the power supply LED turns on.
5. Connect a power cord to the new power supply.
6. Attach the other end of the power cord to the power source.
The power supply LED turns amber to indicate that the power supply is receiving power.
The LED turns green to indicate that it is receiving power and is giving power to the
appliance (only occurs if appliance is on). The high-pitched whine stops and the PS FAIL
light on the front of the appliance turns off.
Copyright © 2012, Juniper Networks, Inc. 54
IDP250 Installation Guide