Sanyo DSR - 300 - Manual (Page 123)

122
English
(when optional interface board is installed)
NETWORK OPE
RATIO
N
5
SAVING RECORDED IMAGES
You can use the procedures described below to copy
recorded images to the hard disk’s archive area or to
download images to a PC or the like.
These functions should be used to backup important
images from the normal recording area and the alarm
recording area.
z Copied data is stored one image at a time. Moving
images can be copied by setting the number of images
required from the first copied image.
z In a single copy operation, a maximum of 10,000
images can be copied to the archive area and a
maximum of 1,000 images can be downloaded to a PC.
z In certain cases where network-busy is detected as a
result of hardware conditions, the network may be
forcibly disconnected in order to protect DVR recording
operations. Furthermore, the network will be forcibly
disconnected in response to a command to send a
large amount of data in a single operation (in particular,
when 100 images or more are to be saved), and in such
a case, a limit should be applied to the number of
images based on the hardware configuration in
question.
z When the archive area becomes full of images, these
images are to be downloaded to a CompactFlash card
or the like, and [AREA FULL RESET] from the
recording area settings on the MAIN MENU should be
clicked. (JP. 101)
(1) Recording date/time: The recording date and time for
the image currently being played back
(2) PLAYBACK AREA:
The area in which the image currently being played
back is recorded
z
NORMAL
z ALARM
(3) HOW MANY: Setting for the number of images to be
stored
(4) Message box: Displays the state of progress for
copying
(5) [START]: Starts copying
1
Play an image from the normal
recording area or the alarm recording
area.
2
Click the button at the start of the
image to be copied.
Playback of the image is paused.
3
Click the button on the operation
panel.
The COPY screen is displayed.
4
Input the number of images into “HOW
MANY”.
Specifically, indicate the number of images after the start
image to be copied in succession.
Setting range: 1 to 10,000
A warning message will be displayed if an invalid number
is entered here.
5
Click [START].
Copying to the archive area will begin and the message
box will display the current state of progress.
[Settings]
Copying to the archive area
(3)
(4)
(1)
(2)
(5)
Setting Description
Copying “COPYING TO ARCHIVE AREA!”
Copying completed “COPY FINISHED!”
e00_l8had_us_7.book Page 122 Wednesday, March 10, 2004 2:47 PM