Sanyo DSR - 300 User Manual
Page 68
ALARM REC MODE SET
8
English
67
z
This unit’s motion sensors cannot be used when a
multiplexer is connected. In such a case, please use the
multiplexer’s motion sensors.
z
When using the multiplexer’s motion sensors, connect
the alarm output on the multiplexer to this unit’s alarm
input.
z
When using a multiplexer, connect its ground terminal
and the recorder's ground terminal.
If a motion sensor is set on the monitor, alarm recording
will be carried out when a moving subject is detected.
1
Move the cursor to “MOTION SENSOR”
and press the [ ] button.
The motion sensor screen is displayed.
2
Press the [ ] or [ ] button to select
sensor operation positions (up to 80),
then press the [
] or [
] button to
confirm the selection.
Press the [
] or [
] button to turn sensors “ON” (shown
as J) and “OFF” (shown as
).
3
Move the cursor to “LEVEL”, then press
the [
] or [
] button to change the
setting.
[Settings] ( indicates default setting.)
4
Move the cursor to “EXIT”, then press
the [
] or [
] button to return to the
<ALARM REC MODE SET> screen.
5
Press the [EXIT/OSD] button.
The display returns to the normal screen.
If recording is ended during alarm recording
using the motion sensor
Set the sensitivity from the motion sensor screen to
“OFF”. (See the procedure 3.)
z
Pressing the [MENU RESET] button in the motion
sensor screen sets the entire row in which the cursor is
located.
Setting the motion sensor
Motion sensor
screen
Setting
example
Setting
Description
OFF
Not carried out
1 to 10
Motion sensing will be carried out. Lower values
correspond to higher sensitivities.
e00_l8had_us_7.book Page 67 Wednesday, March 10, 2004 2:47 PM