Sanyo DSR - 300 - Manual (Page 67)

ALARM REC MODE SET 8
66
English
SE
TTIN
GS <MAIN
MENU 1>
1
Move the cursor to “PRE-ALARM
RECORDING” and press the [ ] button,
then press the [
] or [ ] button to
change the setting.
[Settings] (‹ indicates default setting.)
2
Move the cursor to “REC RATE” and
“DURATION” and press the [ ] button,
then press the [
] or [ ] button to
change the setting.
The maximum number of images (shown in parentheses)
changes in accordance with the new settings.
[Setting conditions]
z
When performing pre-alarm recording with a “FIELD”
recording rate, short settings (i.e., 60.00 or 30.00 FPS)
cannot be made for “REC RATE”. (JP. 48)
z When normal recording and pre-alarm recording are
performed simultaneously, audio will not be recorded
together with the pre-alarm recording image.
z When pre-alarm recording and normal recording are
performed simultaneously with a multiplexer connected,
the recording rate for pre-alarm recording should be set
to a shorter rate than that for normal recording.
z Although the image from a single camera may be
recorded continuously when a short recording rate is
set, a long rate can result in no images being recorded
during normal recording.
Press the [EXIT/OSD] button.
The display returns to the normal screen.
“PRE” appears in the operation display area. When an
alarm occurs, “ALARM” is displayed.
This setting indicates how intruders are to be detected.
1
Move the cursor to “ALARM TRIGGER”
and press the [ ] button, then press the
[
] or [ ] button to change the
setting.
[Settings] (‹ indicates default setting.)
[Setting conditions]
z
When sensor selection has been made (i.e.,
“SENSOR”, “ALARM AND SENSOR”, or “ALARM OR
SENSOR”) it will be necessary to set the motion
sensors.
(J P. 67)
Setting pre-alarm recording
Setting Description
‹ OFF Pre-alarm recording is not carried out
ON Pre-alarm recording is carried out
Maximum number
of images
When settings have been completed
Setting the alarm trigger
Setting Description
‹ ALARM
Performs alarm recording when an external
alarm is generated (when a switch is attached to
the alarm input terminal on the rear panel, and
the switch is activated).
SENSOR
Performs alarm recording when a motion sensor
detects movement. See the information on
setting motion sensors. (JP. 67)
ALARM
AND
SENSOR Performs alarm recording when both the
external alarm and a motion sensor are
activated simultaneously.
ALARM OR
SENSOR Performs alarm recording when either the
external alarm or a motion sensor is activated.
Number of alarm
recordings
PRE display
10-20-04 PRE 0023
08: 30: 00 EN 10FPS
e00_l8had_us_7.book Page 66 Wednesday, March 10, 2004 2:47 PM