Sanyo DSR - 300 - Manual (Page 36)

SEARCHING FOR RECORDED IMAGES 6
English
35
9
Press the [ ] button.
The motion sensor setting screen is displayed.
Motion sensors should be set at locations where
movement is to be detected and viewed.
See “Setting the motion sensor” (JP. 67) for details.
10
Move the cursor to “EXIT” and press the
[
] or [ ] button.
The display returns to the <MOTION DETECTION
SEARCH> screen.
11
Press the [ ] or [ ] button to select
“PREVIEW”.
12
Press the [ ] button.
Each time the [ ] button is pressed, a different motion
sensor screen will be displayed on the preview screen.
„ If “NOT FOUND!” is displayed
No motion sensors have been set. A motion sensor
must be set to allow a screen to be displayed.
1
Press the [ ] or [ ] button to select
“VIEW”.
2
Press the [ ] button.
Normal playback will be started for the specified image.
Using this unit in combination with a multiplexer
z
By specifying the camera number (or channel) and
performing “MOTION DETECTION SEARCH”,
playback can be carried out for only the specified
camera number.
In such a case, the multiplexer title information, date
information, and/or time information may partially
disappear.
z To playback an image from a different camera, stop
playback and then repeat the setting process from the
beginning.
Setting
example
Viewing a motion sensor on-screen
e00_l8had_us_7.book Page 35 Wednesday, March 10, 2004 2:47 PM