Sanyo DSR - 300 - Manual (Page 70)

English
69
(when optional interface board is installed)
2
RS-232C/RS-485 SET
This section describes the settings to be made for
communicating using an RS-232C or RS-485 cable. (A
separately-sold option board will be required in such a
case.)
1
Press the [MENU] button twice.
The <MAIN MENU 2> screen appears.
2
Press the [ ] or [ ] button to select
“2. RS-232C/RS-485 SET”, and press the
[ ] button.
The <RS-232C/RS-485 SET> screen appears.
3
Press the [ ] button.
“RS-232C” flashes. Press the [ ] or [ ] button to select
either “RS-232C” or “RS-485”.
Connect a special RS-232C cable (sold separately)
between this unit’s RS-232C port and the PC.
4
Select “RS-232C” and press the [ ]
button.
The cursor moves to “DATA SPEED”.
5
Press the [ ] button, then the [ ] or
[ ] button to select the “DATA
SPEED”.
Possible selections: 2400, 4800, 9600, and 19200
6
Press the [EXIT/OSD] button.
The display returns to the normal screen.
<MAIN MENU 2> [MENU] button [ ] button [ ] button
[ ] button
[ ] button
[EXIT/OSD] button
Settings for RS-232C and RS-485 When RS-232C is selected
PC
RS-232C terminal
e00_l8had_us_7.book Page 69 Wednesday, March 10, 2004 2:47 PM