Sony PCS-G70P - Manual (Page 149)

PCS-G70/G70P
3-863-237-11 (1)
Y:\04C08060_passage\EDIT\07OPE.FM masterpage:Left
149
Using Audio/Video Signal from the Connected Equipment for a Conference
When the PCS-PG70/PG70P is used as a receiving terminal
: High, a : Middle, f : Low
For details about the settings concerning video output from each output
connector, see “Displaying the Picture on a Projector or Monitor” on page
151, and the Video Setup menu “Monitor Out” on page 52.
Monitor used to
display the picture of
the Data solution Box Output
connector for a
computer
picture on
receiving
terminal Resolution Video
frame
rate Picture quality
VIDEO OUT 1 or
VIDEO OUT 2 VIDEO OUT 1
or VIDEO OUT
2 on the PCS-
PG70/PG70P a a Outputs the signal by
converting a transmitted
VGA, SVGA or XGA signal
into a 4CIF signal. The
original high-resolution
picture cannot be obtained
and details cannot be clearly
seen. The number of frames
displayed per second
depends on the interface
transmission rate. For
example, one frame per
second is obtained at 1 Mbps.
RGB OUT RGB OUT
on the
PCS-PG70/
PG70P a Outputs the signal by
converting a transmitted
VGA, SVGA or XGA signal
into an XGA signal. The
high-resolution picture can
be obtained. The number of
frames displayed per second
depends on the interface
transmission rate. For
example, one frame per
second is obtained at 1 Mbps.
DSB RGB OUT
on the
PCSA-DSB1S
(only when the
PCSA-DSB1S
is enabled) Outputs the signal by
converting a transmitted
VGA, SVGA or XGA signal
into an XGA signal. The
high-resolution picture can
be obtained. You can view
more vivid picture than the
picture output from the RGB
OUT connector on the
Communication Terminal.
The number of frames
displayed per second
depends on the interface
transmission rates. For
example, five frames per
second is obtained at 1 Mbps.