Using the cascade connection via, Lan (up to 10 points) – Sony PCS-G70P User Manual
Page 164
164
Connection Examples for a Multipoint Videoconference
PCS-G70/G70P
3-863-237-11 (1)
Y:\04C08060_passage\EDIT\09OPE.FM
masterpage:Left
Installing the optional PCSA-M3G70 H.323MCU software in two
Communication Terminals enables cascade connection, allowing you to
conduct a multipoint videoconference with up to ten points.
• Installing the PCSA-M3G70 H.323 MCU software into three or more
Communication Terminals does not allow cascade connection. Note that the third or
later terminals should set “Multipoint Mode” to “Off” on page 4 of the
Communication Setup menu.
• For cascade connection, the “Split” and “Split (Fixed)” modes are not available. Only
the “Voice Activate” mode is available.
Using the Cascade Connection via LAN (Up to 10 Points)
Notes
POWER
POWER
POWER
POWER
POWER
POWER
POWER
POWER
TERMINAL
VISCA OUT
(MIXED)
AUX
AUX
MONITOR
LINE
AUX CONTROL
MCU VIDEO OUT
VIDEO OUT
AUDIO OUT
AUDIO IN
MIC
MAIN
SUB
EC-MIC
CTRL-S
RGB OUT
DSB
ISDN UNIT
IR OUT
1
2
1
2
3
4
1
2
1
2
1
2
5
DC 19.5V
CAMERA
CAMERA
AUX IN
AUX IN
WHITE
BOARD
100BASE-TX/
10BASE-T
(PLUG IN POWER)
POWER
LAN
LAN
PCSA-
M3G70
H.323 MCU
software
to 100BASE-TX/
10BASE-T
UTP cable (category 5,
straight) (not supplied)
to LAN
PCSA-M3G70 H.323
MCU software