Schneider Electric 174 CEV - Manual (Page 20)

Installing the Bridge Hardware
16
2.4
Mounting the Bridge Hardware
Replace the bridge enclosure cover. Do not apply power to the bridge yet.
The bridge is supplied with two mounting brackets. Install them on the bridge’s
side or bottom panel as shown in Figure 5, using the screws provided.
If you use your own hardware, use 6--32 machine screws and do not allow any
screw to protrude more than 1/4 in (6 mm) into the bridge.
Secure the bridge to a vertical panel or horizontal shelf with screws through the
mounting bracket holes.
Mounting Requirements
Provide adequate service access to the rear panel LEDs and cable connectors.
Also note the requirements for venting clearances as shown in Figure 6.
Figure 5 Mounting Dimensions
164 mm
Side
Panel
Mounting
Bottom
Panel
Mounting
Do not allow screws to protrude more than 1/4 in (6 mm) inside Bridge.
243
mm
138 mm
164 mm