Schneider Electric 174 CEV - Manual (Page 26)

Installing the Bridge Hardware
22
2.8
Factory Default Settings
This information is provided to allow the installer to restore the factory default
settings, in case one of them is altered inadvertently.
2.8.1 Ethernet Card Defaults
The only user--configurable setting on the card is in jumper JP2 for selecting the
Ethernet connector. This must be set for the connector you are using. Defaults
are shown in Figure 10.
Figure 10 Ethernet Card Defaults
SW1
JP1 JP2
SW1 JP1 JP2
3
2
1
2
1
Do Not change
this
jumper
UTP
(10Base--T)
AUI
(10Base--5)
BNC
(10Base--2)
Set this jumper for the
Ethernet connector
used on your network:
Do Not change
these
switches
2 = AUI
1 = UTP/BNC (Default)