Schneider Electric 174 CEV User Manual
Page 50
Using the Bridge Software
46
H
Make sure your Ethernet packet driver program will be called as it was setup
by the driver installation. Refer to your driver guidebook to ensure that it will
be called properly.
The driver may be called from your AUTOEXEC.BAT or CONFIG.SYS file.
Note that you can also call the driver from your new GATELOOP.BAT file.
If necessary, edit GATELOOP.BAT to call the driver. Typical calls to drivers
pass a command line parameter 0x60 (hexadecimal 60) to define the driver
interrupt.
H
Edit your CONFIG.SYS file to call the Modbus Plus driver MBPHOST.SYS.
The entry must be:
DEVICE=MBPHOST.SYS /md000 /s5d /n0 /r2
H
If you intend to start your bridge application at bootup of your PC, edit your
AUTOEXEC.BAT file to call GATELOOP.BAT. There are no parameters.
Reboot your PC to start the bridge application.
If you intend to start your bridge application from your PC’s command line
prompt, reboot your PC to set the changes in AUTOEXEC.BAT and
CONFIG.SYS. Then start GATELOOP.BAT from the command line.
There are no parameters.
H
Setup your bridge’s internal configuration as described in section 3.2.