Schneider Electric 174 CEV - Manual (Page 27)

Installing the Bridge Hardware
23
2.8.2 Modbus Plus Card Defaults
This card contains two sets of switches. As you view the card at its top edge, the
I/O Base Address switches are located nearest to the end of the card. These
switch settings should not be changed.
The only user--configurable setting on the card is in the Modbus Plus Address
switches. These must be set to the Modbus Plus node address that will be used
by the bridge in your application (see section 2.2 for details).
Factory default settings are shown in Figure 11.
Figure 11 Modbus Plus Card Defaults
Modbus Plus
Address Switches
I/O Base
Address Switches
Set these switches to the
Modbus Plus address
for the bridge
Card
Edge
Do Not change
these
switches