SUPER MICRO Computer SUPERSERVER 6015B-T - Manual (Page 12)

S UPER S ERVER 6015B-T+/6015B-8+ Manual
1-2
1-2 Serverboard Features
At the heart of the SuperServer 6015B-T+/6015B-8+ lies the X7DBR-i+/X7DBR-8+
a dual Xeon processor serverboard based on the Intel 5000P chipset and designed
to provide maximum performance. Below are the main features of the X7DBR-
i+/X7DBR-8+. See Figure 1-1 for a system block diagram of the chipset.
Processors
The X7DBR-i+/X7DBR-8+ supports single or dual dual-core Intel Xeon 5000/5100
Sequence processors at a 1333 MHz FSB in LGA 771-pin sockets. Please refer
to our web site for a complete listing of supported processors.
Memory
The X7DBR-i+/X7DBR-8+ has sixteen 240-pin DIMM slots that can support up
to 64 GB of ECC DDR2-667/533 FBD (Fully Buffered Data) SDRAM. The dual-
channel memory bus requires memory modules to be installed two at a time.
Serial ATA
An on-chip (ESB2) SATA controller is integrated into the X7DBR-i+/X7DBR-8+
to provide a six-port, 3 Gb/sec Serial ATA subsystem, which is RAID 0, 1 and 10
supported. The SATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
Onboard SCSI (6015B-8+ only)
An onboard Adaptec AIC-7902 dual-channel SCSI controller in integrated into the
X7DBR-8+ , which supports 80-pin SCA Ultra320 SCSI hard drives. The SCSI
drives are connected to an SCA backplane that provides power, bus termination
and confi guration settings. The SCSI drives are hot-swappable units.
Two (2) passive 1U CPU heatsinks (SNK-P0017)
SuperServer 6015B-T+/6015B-8+ User's Manual
Note: the 6015B-T+/6015B-8+ comes in silver and black (no beige). A "B" at the end
of a part number indicates the item is available in black, a "V" indicates silver.