SUPER MICRO Computer SUPERSERVER 6015B-T - Manual (Page 24)

2-8
S UPER S ERVER 6015B-T+/6015B-8+ Manual
2-5 Checking the Serverboard Setup
After you install the 6015B-T+/6015B-8+ in the rack, you will need to open the unit
to make sure the serverboard is properly installed and all the connections have
been made.
1. Accessing the inside of the 6015B-T+/6015B-8+ (see Figure 2-5)
First, grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top of the
chassis to release the top cover. There is a large rectangular recess in the
middle front of the top cover to help you push the cover away from you until it
stops. You can then lift the top cover from the chassis to gain full access to
the inside of the server.
2. Check the CPUs (processors)
You should have one or two processors already installed into the serverboard.
Each processor needs its own heatsink. See Chapter 5 for instructions on pro-
cessor and heatsink installation.
3. CPU Speed
The CPU speed should automatically be detected so you will not need to change
any jumpers or settings in the BIOS Setup utility.
4. Check the system memory
Your 6015B-T+/6015B-8+ server system may have come with system memory
already installed. Make sure all DIMMs are fully seated in their slots. For details
on adding system memory, refer to Chapter 5.
5. Installing add-on cards
If desired, you can install add-on cards to the system. See Chapter 5 for details
on installing PCI add-on cards.
6. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking
the chassis airfl ow. See Chapter 5 for details on cable connections.