SUPER MICRO Computer SUPERSERVER 6015B-T - Manual (Page 3)

Preface
About This Manual
This manual is written for professional system integrators and PC technicians.
It provides information for the installation and use of the SuperServer 6015B-
T+/6015B-8+. Installation and maintenance should be performed by experienced
technicians only.
The SuperServer 6015B-T+/6015B-8+ is a high-end 1U rackmount server based
on the SC815TQ-700/SC815S-700 1U rackmount server chassis and the X7DBR-
i+/X7DBR-8+ serverboard, which supports single or dual Intel® Xeon 5100/5000
series processors at a Front Side (system) Bus speed of 1333 MHz and up to 64
GB of ECC DDR2-667/533 FBD SDRAM memory.
Manual Organization
Chapter 1: Introduction
The fi rst chapter provides a checklist of the main components included with the
server system and describes the main features of the SUPER X7DBR-i+/X7DBR-
8+ serverboard and the SC815TQ-700/SC815S-700 chassis, which make up the
SuperServer 6015B-T+/6015B-8+.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer 6015B-
T+/6015B-8+ into a rack and check out the server confi guration prior to powering
up the system. If your server was ordered without processor and memory com-
ponents, this chapter will refer you to the appropriate sections of the manual for
their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
iii
Preface