SUPER MICRO Computer SUPERSERVER 6015B-T - Manual (Page 50)

5-16
S UPERSERVER 6015B-T+/6015B-8+ User’s Manual
ATX PS/2 Keyboard and
PS/2 Mouse Ports
The ATX PS/2 keyboard and the PS/2
mouse ports are located on the I/O
back plane. See the table on the right
for pin defi nitions.
Power LED/Speaker
On the JDI header, pins 1-3 are for
a power LED, pins 4-7 are for the
speaker. See the table on the right
for speaker pin defi nitions.
Note: The speaker connector pins are
for use with an external speaker. If
you wish to use the onboard speaker,
you should close pins 6-7 with a
jumper.
PS/2 Keyboard and
Mouse Port Pin
Defi nitions (Kb, Mouse)
Pin# Defi nition
1 Data
2 NC
3 Ground
4 VCC
5 Clock
6 NC
Speaker Connector
Pin Defi nitions (JD1)
Pin # Function Defi nition
4 + Speaker data (red wire)
5 Key No connection
6 Key
7 Speaker data
Extra Universal Serial Bus
Headers
Four USB headers are located near
the SATA ports on the serverboard.
JUSB2 includes USB2/3 and JUSB3
is for USB4/5. A USB cable (not
included) is needed for the connec-
tion. See the table on the right for
pin defi nitions.
Front Panel Universal Serial Bus
Pin Defi nitions (JUSB2/3)
USB2/4
Pin # Defi nition USB3/5
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 N/A
Overheat LED
Connect an LED to the JOH1 header
to provide warning of a chassis over-
heating condition. See the table on the
right for pin defi nitions.
Overheat LED
Pin Defi nitions (JOH1)
Pin# Defi nition
1 +5V
2 OH Active