SUPER MICRO Computer SUPERSERVER 6015B-T - Manual (Page 55)

Chapter 5: Advanced Serverboard Setup
5-21
SCSI Controller Enable/
Disable (6015B-8+ only)
Jumper JPA1 is used to enable or dis-
able the onboard SCSI controller. The
default setting is on pins 1-2 to enable
SCSI. See the table on the right for
jumper settings.
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SCSI Termination Enable/
Disable (6015B-8+ only)
Jumpers JPA2/JPA3 are used to en-
able or disable termination for the
SCSI Channel A (JPA2) and Channel B
(JPA3) connectors. The default setting
is open to enable termination. See the
table on the right for jumper settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.
SCSI Term. Enable/Disable
Jumper Settings (JPA2/JPA3)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled