SPX Cooling Technologies Evaporative Air Cooler FSIG-TS-08A - Manual (Page 9)

Marley / Sigma F Series Cooling Tower / Engineering Data : Piping Plan 4
9
C
H
MOTOR
C
F
COLUMN AND
ANCHOR BOLT
TYP. SINGLE CELL
D
TYP. MULTICELL
CL COLUMN AND
ANCHOR BOLT
CL
RISER AND HEADER
C L
TOWER
AND F
AN
C L
FAN CL FAN CL
RISER CL
H
E
G
FAN FLANGE IS 3 / 4 " THICK. BOLT
CIRCLE CONFORMS TO 125 LB.
ANSI SPECIFICATIONS 10 1 / 8 "
1'-7"
BASE OF
TOWER COLUMNS
RISER CL CL
C L
FACE OF
A
DIA. GALVANIZED FLANGE
F
FAN TOWER CL
INLET RISER CL
MOTOR
CONCRETE
BASIN OPTION
B
DIAMETER
CROSSOVER PIPE
STAINLESS
STEEL BASIN
OPTION
END ELEVATION SIDE ELEVATION
NOTE
1 Use this bulletin for preliminary layouts only. Obtain current
drawings from your Marley representative.
2 Pumping head contributed by the tower is static lift E. Actual
pumping head will vary according to tower circulating GPM. Total
pumping head will be furnished at time of proposal.
3 If your application requires a bypass system, recommended location
is through the tower endwall into the plenum area. Review of the
system by SPX engineering is required.
4 All header and riser piping to be furnished by others. A corrosion-
resistant material or coating for piping is recommended. Do not
support riser dead load or operating load from inlet connection or
tower structure.
PLAN