Wireless interface commands – SMC Networks SMC2552W-G2-17 User Manual
Page 230
Wireless Interface Commands
7-93
7
Example
Wireless Interface Commands
The commands described in this section configure connection parameters for the
wireless interfaces.
Enterprise AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address : 192.168.2.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.253
Primary DNS : 192.168.1.55
Secondary DNS : 10.1.0.55
Speed-duplex : 100Base-TX Half Duplex
Admin status : Up
Operational status : Up
========================================
Enterprise AP#
Table 7-17. Wireless Interface Commands
Command
Function
Mode
Page
interface wireless
Enters wireless interface configuration mode
GC
vap
Provides access to the VAP interface configuration
mode
IC-W
speed
Configures the maximum data rate at which the
access point transmits unicast packets
IC-W
turbo
Configures turbo mode to use a faster data rate
IC-W (a)
7-96
multicast-data-rate
Configures the maximum rate for transmitting
multicast packets on the wireless interface
IC-W
channel
Configures the radio channel
IC-W
transmit-power
Adjusts the power of the radio signals transmitted
from the access point
IC-W
radio-mode
Forces the operating mode of the 802.11g radio
IC-W (b/g)
preamble
Sets the length of the 802.11g signal preamble
IC-W (b/g)
antenna control
Selects the antenna control method to use for the
radio
IC-W
antenna id
Selects the antenna ID to use for the radio
IC-W
antenna location
Selects the location of the antenna
IC-W