Savin DSc332 - Manual (Page 138)

User Tools (Copier/Document Server Features)
124
5
Input/Output
❖ ❖ ❖ ❖ Switch to Batch (SADF)
You can select to have the Batch or
SADF function displayed when
you press [Special Original]. See p.15
“Batch”.
Note
❒ Default: Batch
❖ ❖ ❖ ❖ SADF Auto Reset
In SADF mode, an original must be
set within a specified time after the
previous original has been fed.
You can adjust this time from 3 sec-
onds to 99 in 1 second increments.
Note
❒ Default: 5 seconds
❖ ❖ ❖ ❖ Rotate Sort: Auto Paper Continue
You can continue copying when
paper of the required orientation
has run out during rotate-sorting.
See p.43 “Rotate Sort”.
Note
❒ If you select [No] :
• When paper of the required
orientation runs out, the ma-
chine stops copying and
prompts you to supply copy
paper. When you load paper,
the machine will continue
copying.
❒ If you select [Yes] :
• Copying continues using
copy paper of a different ori-
entation. The copy job will
finish even if the machine is
left unattended.
❒ Default: No
❖ ❖ ❖ ❖ Auto Sort
You can specify whether the Sort
function is to be selected when the
machine is turned on, or when the
functions are cleared.
Note
❒ Default: No
❖ ❖ ❖ ❖ Memory Full Auto Scan Restart
If memory becomes full while
scanning originals, the machine
will copy the scanned originals
first, and then automatically pro-
ceed scanning remaining originals.
You can enable or disable this
function.
Note
❒ If you select [No] :
• When memory becomes full,
the machine stops operation,
allowing you to remove the
copies on the output tray.
❒ If you select [Yes] :
• You can leave the machine
unattended to make copies,
but sorted pages will not be
sequential.
❒ Default: No
❖ ❖ ❖ ❖ Select Stack Function
Specify whether Stack or Rotate
Sort has priority on the initial dis-
play.
Note
❒ Default: Stack
❒ An 2 tray finisher or booklet fin-
isher is required to use this
function.
0827JupiterC1_Copy_EN_F1_FM.book Page 124 Thursday, September 4, 2003 5:06 PM