Savin DSc332 - Manual (Page 78)

Copying
64
2
Specified Area Repeat
You can use this function only when
you are making a copy from the Ex-
posure Glass.
Note
❒ The base point X1, Y1, and the
length set by point X2, Y2 deter-
mines the area of an image repeat-
edly copied.
Limitation
❒ You cannot use the specified area
repeat from ADF.
1. Set on the exposure glass
AAAA
Specify the location of the area's
base point (X1, Y1), and its length
and width (X2, Y2).
Note
❒ You can set any value in the
r a n g e o f X 1 : 0 ~ 4 1 2 m m
( 0” ~ 1 6 .2 ” ) , X 2 : 20 ~ 4 3 2 m m
(0.8”~17.0”), Y1: 0~277mm
(0”~10.8”), and Y2: 20~297mm
(0.8”~11.6”).
BBBB
Select the size of the copy paper
and the reproduction ratio.
CCCC
Press [Edit/Color Creation].
DDDD
Press [Edit Image].
EEEE
Press [Image Repeat].
FFFF
Press [Specified Area].
GGGG
Enter the length of [X1] with the
number keys, then press [#].
HHHH
Enter the length of [Y1] with the
number keys, then press [#].
IIII
Enter the length of [X2] with the
number keys, then press [#].
JJJJ
Enter the length of the [Y2] by
number keys, then press [#].
KKKK
Press [OK] three times.
LLLL
Place the original on the exposure
glass, and then press the
{{{{Start}}}}
key.
Double Copies
One original image is copied twice
onto one sheet, as shown.
Note
❒ You cannot use the bypass tray
with this function.
❒ See the following table for original
and copy paper sizes and orienta-
tions when using a 100% ratio:
0827JupiterC1_Copy_EN_F1_FM.book Page 64 Thursday, September 4, 2003 5:06 PM