Siemens Gigaset S450IP - Manual (Page 30)

29
Appendix
Gigaset S450 IP KBA / EN US / A31008-M1713-R321-2-6043 / appendix.fm / 17.1.07
Ve
rs
ion 4,
16
.09.
2005
General specifications FCC / ACTA Information
Warning
: Changes or modifications to this unit
not expressly approved by Siemens Cordless
Products could void the FCC authority to oper-
ate the equipment. This includes the addition of
any external antenna device.
This equipment complies with Part 68 of the
FCC rules and the requirements adopted by the
ACTA. On the bottom of the base station is a
label that contains, among other information,
a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number
must be provided to the telephone company.
A plug and jack used to connect this equipment
to the premises wiring and telephone network
nust comply with the applicable FCC Part 68
rules and requirements adopted by the ACTA.
A compliant telephone cord and modular plug
is provided with this product. It is designed to
be connected to a compatible modular jack that
is also compliant. See installation instructions
for details.
The REN is used to determine the number of
devices that may be connected to a telephone
line. Excessive RENs on a telephone line may
result in the devices not ringing in response to
an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To be
certain of the number of devices that may be
connected to a line, as determined by the total
RENs, contact the local telephone company.
For products approved after July 23, 2001, the
REN for this product is part of the product iden-
tifier that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN with-
out a decimal point (e.g., 03 is a REN of 0.3).
For earlier products, the REN is separately
shown on the label.
If this equipment causes harm to the telephone
network, the telephone company will notify you
in advance, that temporary discontinuance of
service may be required. But if advance notice
isn’t practical, the telephone company will
notify the customer as soon as possible. Also,
you will be advised of your right to file a com-
plaint with the FCC if you belive it is necessary.
The telephone company may make changes in
its facilities, equipment, operations or proce-
dures that could affect the operation of the
equipment. If this happens the telephone com-
pany will provide advance notice in order for
you to make necessary modifications to main-
tain uninterrupted service. If you experience
trouble with this telephone system, disconnect
it from the network until the problem has been
Interfaces Fixed network, Ethernet
No. of channels 60 duplex channels
Radio frequency-
range
1880–1900 MHz
Duplex method Time multiplex,
10 ms frame length
Channel grid 1728 kHz
Bit rate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission
power
10 mW, average power per
channel
Range up to 328 yards outdoors,
up to 55 yards indoors
Base station
power supply
230 V ~/50 Hz
Environmental
conditions in oper-
ation
+41°F to +113°F;
20% to 75% humidity
Dialing mode DTMF (touch tone dialing)/
DP (dial pulsing)
Flashing time 250 ms
Codecs G711, G726, G729AB with
VAD/CNG
Quality of Service TOS, DiffServ
Protocols
DECT, GAP, SIP, RTP, DHCP,
NAT Traversal (STUN),
HTTP