Siemens Gigaset S450IP - Manual (Page 8)

7
First steps
Gigaset S450 IP KBA / EN US / A31008-M1713-R321-2-6043 / starting.fm / 17.1.07
Ve
rs
ion 4,
16
.09.
2005
Initial charging and discharging of
batteries
Battery charging is indicated in the top
right of the display by a flashing battery
icon e, V or U. During handset oper-
ation, the battery icon indicates the
charge status of the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged and discharged through use.
¤
To do this, leave the handset in the
charging cradle without interruption
until the battery icon stops flashing in
the display (approx. 13 hours).
¤
Once the batteries are fully charged,
remove the handset from the charging
cradle and do not put it back again until
the batteries are fully discharged.
Please note:
u Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u The batteries may warm up as they are
charging. This is not dangerous.
u After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Setting the date and time
If the date and time are not yet set on the
phone, the display key §Time§ is displayed.
You can set the date and time later via the
menu v
¢
Ð Settings
¢
Date/Time .
¤
Press §Time§ or open the menu.
¤
Change multiple line input:
Date:
Enter month, day and year in 6-digit
format.
Time:
Enter hours and minutes as 4 digits
(e.g. Q M 1 5 for 07:15 am
If you have selected the 12-hour time for-
mat, use the display key §am/pm§ to switch
between am and pm.
Time Mode:
Choose between 12 and 24-hour time
format.
§Save§ Press the display key.
The date and time are shown in the hand-
set's idle display (page 1).
Area codes
In order to call back a caller using the calls
list (page 20), your phone's area code
("local area code") must be stored. If your
phone is in a "multiple area code" area, the
extra codes for this area must also be
stored.
Area Code
v
¢
Ð Settings
¢
Telephony
¢
Area Code
~ Enter local area code.
§Save§ Press the display key.
a Press and hold (idle status).
Extra Codes
v
¢
Ð Settings
¢
Telephony
¢
Extra Codes
q Select an entry and press §Edit§ .
~ Enter extra code.
§Save§ Press the display key.
Note:
After the first battery charge and discharge,
you may replace your handset in the charging
cradle after every call.
Note:
You will find explanations of the icons and
typographical conventions used in this user
guide in the detailed user guide for your
Gigaset S450 IP available online at
www.siemens.com/gigaset.