Siemens Gigaset S450IP - Manual (Page 7)

6
First steps
Gigaset S450 IP KBA / EN US / A31008-M1713-R321-2-6043 / starting.fm / 17.1.07
Ve
rs
ion 4,
16
.09.
2005
Setting up the handset for use
The display is protected by a
protective plastic film.
Please remove the protec-
tive film!
Inserting the batteries
¤
Insert the batteries the right way round
(see figure).
The polarity is indicated in/on the battery
compartment.
The handset turns on automatically.
You will hear a confirmation tone.
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Place your finger in the headset socket
cavity and pull the battery cover
upwards.
Connecting the charging cradle
Connecting up the charging cradle and
mounting it on the wall (if required) is
described at the end of this user guide.
¤
To charge the batteries, leave the hand-
set in the charging cradle.
Warning:
Use only the rechargeable batteries recom-
mended by Siemens on page 28! This means
that you must not use conventional (non-
rechargeable) batteries or other types of bat-
teries. If you do, serious damage to health and
property cannot be ruled out: for example, the
outer casing of the batteries could be
destroyed or the batteries could explode. The
phone could also malfunction or be damaged
as a result of using batteries that are not of the
recommended type.
Notes:
– Only place the handset in the charging cra-
dle that is intended for it.
– If the handset has turned itself off because
the batteries are flat and it is then placed in
the charging cradle, it will turn itself on
automatically.