Woodstock W1820 - Manual (Page 35)

-33-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
9cX[\J\c\Zk`fe
I`gg`e^YcX[\]\Xkli\j(see =`^li\*0)1
•
Best for cutting with the grain of the workpiece.
• 20-40 teeth.
• Flat-top ground tooth profile.
• Large gullets for large chip removal.
=cXk
Kfg
9cX[\
=`^li\*0. Ripping blade.
:ifjjZlkYcX[\]\Xkli\j(see =`^li\+')1
•
Best for cutting across the grain of the workpiece.
• 60-80 teeth.
• Alternate top bevel tooth profile.
• Small hook angle and a shallow gullet.
:fdY`eXk`feYcX[\]\Xkli\j(see =`^li\+()1
•
Adequate for cutting both with and across the grain.
• 40-50 teeth.
• Alternate top bevel and flat, or alternate top bevel
and raker tooth profile.
• Teeth are arranged in groups of five.
• Gullets are small and shallow within the groups of
five teeth, similar to a cross-cut blade; then large
and deep between each group of five, like a ripping
blade.
CXd`eXk\YcX[\]\Xkli\j(see =`^li\+))1
•
Best for cutting plywood or veneer.
• 40-80 teeth.
• Triple chip tooth profile.
• Very shallow gullet.
8ck\ieXk\
Kfg
9\m\c
=`^li\+'% Crosscutting blade.
8ck\ieXk\
Kfg
9\m\c
Xe[
=cXk
Ki`gc\
:_`g
9cX[\
=`^li\+)%Laminate blade.
=`^li\+(%Combination blade.