Woodstock W1820 - Manual (Page 50)

-48-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
:lkk`e^IXYY\kjn`k_JkXe[Xi[9cX[\
A ripping blade is typically the best blade to use for
cutting rabbets when using a standard blade because it
removes sawdust very efficiently (see Page 33 for blade
details about ripping blades). Also, a sacrificial fence is
not required when cutting rabbets with a standard blade.
KfZlkXiXYY\kn`k_XjkXe[Xi[YcX[\#[fk_\j\jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Ensure that the riving knife and standard table insert
are installed.
*% Mark the width of the rabbet cut on the edge of the
workpiece, so you can clearly identify the intended
cut.
+% Raise the blade up to the desired depth of cut
(depth of rabbet channel desired). When cutting
deep rabbets, take more than one pass to reduce
the risk of kickback.
,% Stand the workpiece on edge, as shown in =`^li\-+,
then adjust the fence so the blade is aligned with the
inside of your rabbet channel.
-% Reconnect the saw to the power source and turn the
saw ON. When the blade has reached full speed, per-
form a test cut with a scrap piece of wood.
— If the cut is satisfactory, repeat the cut with the
final workpiece.
.% Lay the workpiece flat on the table, adjust the
saw blade height to intersect with the first cut, as
shown in
=`^li\-,#then perform the second cut to
complete the rabbet.
K_\[Xe^\if]b`ZbYXZb`eZi\Xj\ji\cX$
k`m\kfk_\[\gk_f]XZlk%I\[lZ\k_\
i`jb f] b`ZbYXZb Yp dXb`e^ dlck`gc\
gXjj\jkfXZ_`\m\k_\[\j`i\[[\gk_f]
Zlk% =X`cli\ kf ]fccfn k_\j\ nXie`e^j
Zflc[i\jlck`ej\i`fljg\ijfeXc`ealip%
=`^li\-+%Rabbet cutting with a standard
blade.
Fence
Blade
W
orkpiece
=`^li\-,%Rabbet cutting with a standard
blade.
Workpiece
Fence
Blade