Woodstock W1820 - Manual (Page 43)

-41-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
:ifjjZlkk`e^
"Crosscutting" means cutting across the grain of a natural
wood workpiece. In other man-made materials, such as
MDF or plywood, crosscuttting means cutting across the
width of the workpiece.
KfdXb\XZifjjZlklj`e^k_\d`k\i^Xl^\#[fk_\j\
jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Ensure that the blade guard/spreader is installed.
*% Move the rip fence aside and position the miter
gauge, adjusted to 90°, in a miter slot.
+% Adjust the blade height so the teeth protrude
approximately 1 /
4
" above the workpiece.
,% Slide the miter gauge near the blade and adjust the
workpiece so the blade will cut on the waste side of
the line.
-% Plug in the table saw, turn it FE# and allow it to
reach full speed.
.% Hold the workpiece firmly against the face of the
miter gauge (see =`^li\,)) and ease it through the
blade until the workpiece is completely past the saw
blade.
=`^li\,)%Typical crosscutting operation.
KlieF==k_\jXnXe[Xccfnk_\YcX[\
kf Zfd\ kf X Zfdgc\k\ jkfg Y\]fi\
i\dfm`e^ k_\ Zlk$f]] g`\Z\% =X`cli\
kf ]fccfn k_`j nXie`e^ Zflc[ i\jlck `e
j\i`fljg\ijfeXc`ealip%
B\\gk_\YcX[\^lXi[`ejkXcc\[Xe[`e
k_\ [fne gfj`k`fe% =X`cli\ kf [f k_`j
Zflc[i\jlck`ej\i`fljg\ijfeXc`ealip
fi[\Xk_%