Woodstock W1820 - Manual (Page 68)

-66-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
J<I
M
@:<
+% Tilt the blade away from 0° by about 5°, so there is
room for the stop bolt to move.
,% Open the motor access cover, loosen the jam nut
shown in =`^li\j 0+Æ0,, adjust the stop bolt up or
down according to how far off the blade was from
90°. Repeat
Jk\g* and, if necessary, make additional
adjustments to the stop bolt until the table stops at
90°.
-% Tighten the jam nut, then close the motor cover.
=`^li\0+% 90° stop bolt and jam nut.
90° Stop
Bolt & Jam
Nut
=`^li\0,. 90° stop bolt and jam nut
(table removed for clarity).
90° Stop Bolt &
Jam Nut
=`^li\0-%Checking blade at 45°.
9cX[\
+,—JhlXi\
KXYc\
J\kk`e^+,—Jkfg9fck
(% DISCONNECT THE SAW FROM POWER!
)% Raise the blade as high as it will go, then tilt it
towards 45° until it stops and cannot be tilted any
more.
*% Place a 45° square against the table and blade so
it contacts the blade evenly from bottom to top, as
shown in
=`^li\0-. Make sure a blade tooth does not
obstruct the placement of the square.
— If the blade is 45° to the table, then adjustments
do not need to be made.
— If the blade is not 45° to the table, you will need
to adjust the 45° stop screw. Proceed to the next
step.
+% Tilt the blade to 15°, so there is room for the stop
bolt to move, then remove the dust port to access the
stop bolt.
,% Loosen the jam nut on the 45° stop bolt (see =`^li\
0.) with a 13mm wrench, adjust the stop bolt up or
down according to how far off the blade was from
45°.
-% Continue adjusting the stop bolt until it contacts the
cabinet when the blade is at 45°, then tighten the
jam nut.
.% Close the dust port.
=`^li\0.% 45° stop bolt and jam nut.
45° Stop Bolt &
Jam Nut