Woodstock W1820 - Manual (Page 74)

-72-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
J<I
M
@:<
=\eZ\JZXc\:Xc`YiXk`fe
The fence scale indicator window, shown in =`^li\('/,
can be calibrated with the fence scale if you notice that
your cuts do not accurately match what is shown on the
fence scale. The indicator adjusts by loosening the two
mounting screws and sliding it in the desired direction.
KffcjE\\[\[ Hkp
Hex Wrench 2.5mm .............................................1
Scrap Piece of Wood ............................................1
KfZXc`YiXk\k_\]\eZ\jZXc\`e[`ZXkfin`e[fnj#[f
k_\j\jk\gj1
(% Position and lock the fence at 13", as indicated by
the scale, cut your scrap piece of wood.
)% Reposition and lock the fence at 12", as indicated by
the scale.
*% Flip your scrap piece of wood over, placing the side
that was cut in Jk\g) against the fence, and cut
your scrap piece of wood.
+% Measure the width of the freshly cut workpiece with
a tape measure. The workpiece width should be
exactly 12". If it is not, then adjust the indicator
window to match the width of the workpiece.
=`^li\('/% Fence indicator window.
Screws
Indicator
Window