Woodstock W1820 - Manual (Page 71)

-69-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
J<I
M
@:<
8[aljk`e^8c`^ed\ek
The spreader/riving knife mounting position can be
adjusted into alignment with the blade using the set
screws on the spreader/riving knife mounting block.
Gfjj`Yc\KffcjE\\[\[ Hkp
Hex Wrench 3mm ...............................................1
Hex Wrench 5mm ...............................................1
To adjust the spreader/riving knife position, do these
steps:
1. DISCONNECT THE SAW FROM POWER!
)% Remove the table insert.
*% Adjust each pair of set screws that controls the
direction required to move the mounting block so
the riving knive can be aligned with the blade (see
=`^li\(')). Make sure to move both screws in even
increments.
+% Re-install the table insert.
,% Follow :_\Zb`e^8c`^ed\ek,Jk\gj(Æ*to determine
if the spreader/riving knife is parallel with the blade
and inside the "Alignment Zone."
— If the spreader/riving knife is in the alignment
zone, no additional steps are necessary.
— If the spreader/riving knife is still not in the
alignment zone, continue adjusting the set screws
on the mounting block as necessary to correctly
position the spreader/riving knife.
-% Tighten the two cap screws on the mounting block to
secure the spreader/riving knife adjustment.
Cap
Screws
Set Screw
=`^li\(')%Set screws for adjusting
spreader/riving knife position.
8c`^ed\ek
Qfe\
D`jXc`^e\[
Jgc`kk\ifi
I`m`e^Be`]\
9cX[\
Adjustment Block
Kfg:fekifc
J`[\
:fekifc
J`[\
:fekifc
9fkkfd:fekifc
Center
Screw
Cap
Screws
8[aljk`e^9\ekJgi\X[\i&I`m`e^Be`]\
(% DISCONNECT THE SAW FROM POWER!
)% Bend the spreader or riving knife by hand while
installed, then follow Jk\gj(Æ* in :_\Zb`e^
8c`^ed\ek to determine if it is parallel with the
blade and inside the "Alignment Zone" (refer to
:_\Zb`e^8c`^ed\ek).
— If this does not work, remove it to straighten.
— If you cannot straighten it properly, replace it.