Woodstock W1820 - Manual (Page 63)

-61-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
Lj`e^k_\8lo`c`Xip=\eZ\Xe[Glj_9cfZb
(% Place the auxiliary fence on the table and clamp it
to the fence at both ends, then adjust the distance
between the auxiliary fence and the blade—this
determines how wide the workpiece will be ripped
(see
=`^li\/,).
)% Install the blade guard, then secure the spreader
pawls in the upright position, as shown in Figure 48
on
GX^\*., so they do not interfere with the push
block lip.
*% Place the workpiece 1" in front of the blade and
evenly against the table and the auxiliary fence.
+% Turn the saw FE, then begin ripping the workpiece
using a push stick for side support.
As the workpiece nears the end of the cut, place
the push block on the auxiliary fence with the lip
directly behind the workpiece, then release the
push stick just before it is even with the blade (see
=`^li\/.). Guide the workpiece the rest of the way
through the cut with the push block, then re-install
the pawls on the spreader when cutting operations
are finished.
Workpiece
Cutting
Width
Blade
Auxilliary Fence
=`^li\85% Adjusting ripping distance
between blade and auxiliary fence.
Auxilliary Fence
Blade
Workpiece
Push Stick
for Side
Support
Blade Path
Push
Block
=`^li\/-% Adjusting ripping distance
between blade and auxiliary fence.
Release
Push Stick
Before Blade
=`^li\ /.. Ripping with push block.
B\\gk_\YcX[\^lXi[`ejkXcc\[Xe[`ek_\[fne
gfj`k`fe%=X`cli\kf[fk_`jZflc[i\jlck`ej\i`flj
g\ijfeXc`ealipfi[\Xk_%