Woodstock W1820 - Manual (Page 53)

-51-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
I\jXn`e^Fg\iXk`fej
The table saw motor is pushed to its limits when
resawing. If the motor starts to bog down, slow down
your feed rate. Motor overloading and blade wear can
be reduced by using a ripping blade. Ripping blades are
designed to clear the sawdust quickly.
:fdgfe\ekjE\\[\[]fiI\jXn`e^1
Zero Clearance Insert ..........................................1
Ripping Blade 10" ...............................................1
Clamps ............................................................2
Shop Made Auxiliary Fence ....................................1
Shop Made Resaw Barrier ......................................1
Kfg\i]fidi\jXn`e^fg\iXk`fej#[fk_\j\jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Remove the standard table insert and the blade
guard assembly.
*% Install a ripping blade and the riving knife, lower the
blade below the table, then install a zero clearance
table insert.
=\eZ\
9f[p
8lo`c`Xip
=\eZ\
=\eZ\
=XZ`e^
=`^li\67% Auxiliary fence.
Pfl dXp \og\i`\eZ\ b`ZbYXZb [li`e^
k_`j gifZ\[li\% JkXe[ kf k_\ j`[\ f]
k_\YcX[\Xe[n\XiX]lcc]XZ\j_`\c[kf
gi\m\ek`ealipn_\ei\jXn`e^%
KfYl`c[k_\Xlo`c`Xip]\eZ\#[fk_\j\jk\gj1
(% Cut the auxiliary fence board to size. If you are using
hardwood, cut the board oversize, then joint and
plane the board to the correct size to make sure the
board is square and flat.
Efk\1Fecplj\]lie`kli\^iX[\gcpnff[fib`ce[i`\[
_Xi[nff[kfgi\m\eknXig`e^%
)% Unthread the fence face mounting hardware and
remove the fence face from the fence assembly.
*% Place the auxiliary fence next the fence face you
removed in Jk\g(, mark the location of the nine
mounting holes on the auxiliary fence, then drill the
holes.
+% Use the mounting hardware that had previously
attached the fence face to attach the auxiliary
fence. The end result should be similar to
=`^li\67.