Woodstock W1820 - Manual (Page 52)

-50-
Df[\cN(/(0&N(/)' D]^%J`eZ\()&('
FG
<
I
8
K@FEJ
DXb`e^I\jXn9Xii`\i
The resaw barrier acts in tandem with the rip fence when
resawing to provide tall support for the workpiece to
minimize the probability of it binding against the blade
and causing kickback.
KffcjE\\[\[]fik_\I\jXn9Xii`\i1
Table Saw ........................................................1
Jointer and Planer ............................. Recommended
Clamps ................................................2 Minimum
Drill and Drill Bits ...............................................1
:fdgfe\ekjE\\[\[]fik_\I\jXn9Xii`\i1
Wood*
3 ⁄
4
" x 6" x Length of Table Saw Fence ...............1
Wood* 3 ⁄
4
" x 3" x Length of Table Saw Fence ...............1
Wood Screws #10 x 2" ..........................................4
Wood Glue ........................................... As Needed
* Fecplj\]lie`kli\^iX[\gcpnff[#b`ce[i`\[_Xi[nff[#
fiL?D?gcXjk`Zkfgi\m\eknXig`e^%
KfYl`c[k_\i\jXnYXii`\i#[fk_\j\jk\gj1
(% Cut your wood pieces to the size specified above.
If you are using hardwood, cut the pieces oversize,
then joint and plane them to the correct size to
make sure they are square and flat.
)% Pre-drill and countersink 4 holes approximately 3 ⁄
8
"
from the bottom of the 6" tall board. These will
be use as pilot holes when attaching the board to
another piece in the next step.
*% Glue the end of the 3" board, then clamp the boards
at a 90° angle with the larger board in the vertical
position, as shown in
=`^li\--, fasten together with
the wood screws.
=`^li\--% Clamping the resawing barrier.
#10 x 2"
Wood Screw
Assembled
Resaw Barrier
3 ⁄
4
"
3 ⁄
4
"
8lo`c`Xip=\eZ\
The auxiliary fence is necessary if you are resawing a
workpiece that is taller than it is wide. It should be no
less than
1 ⁄
2
" shorter than the board to be resawn.
:fdgfe\ekjE\\[\[]fik_\8lo`c`Xip=\eZ\1
Hardwood or Plywood
3 ⁄
4
" x (Height) x Length of Table
Saw Fence ........................................................1
KffcjE\\[\[]fik_\I\jXn9Xii`\i1
Table Saw ........................................................1
Jointer and Planer ............................. Recommended
Clamps ................................................2 Minimum