SMC Networks SMC7004ABR V.2 - Manual (Page 11)

Hardware Description
7
•
4 RJ-45 ports for connection to a 10BASE-T/100BASE-TX
Ethernet Local Area Network (LAN). These ports can
auto-negotiate the operating speed to 10/100 Mbps, the mode
to half/full duplex, and the pin signals to MDI/MDI-X
(i.e., allowing these ports to be connected to any network
device with straight-through cable). These ports can be
connected directly to a PC or to a server equipped with an
Ethernet network interface card, or to a networking device
such as an Ethernet hub or switch.
•
One RJ-45 port for connection to a DSL or cable modem
(WAN). This port also auto-negotiates operating speed to
10/100 Mbps, the mode to half/full duplex, and the pin signals
to MDI/MDI-X.
•
One RS-232 serial port to connect to an ISDN Terminal
Adapter (TA) or to a PSTN analog modem.
•
One parallel printer port that can be connected to a printer.
This printer can then be shared by any LAN users.
The following figure shows the components of the Barricade™
Router:
Figure 1. Front and Rear Panels
SMC7004ABR
Reset
Power WAN
10/100
Link/Act
1 2 3 4
LAN
1 2 3 4
12V 1A WAN COM PRINTER