SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 12)

1-2
S UPER S ERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 6014P-8/6014P-8R/6014P-82R/6014P-82
lies the X6DHP-8G/X6DHP-8G2, a dual processor serverboard based on
Intel's E7520 chipset. Below are the main features of the X6DHP-8G/X6DHP-
8G2 (see Figure 1-1 for a block diagram of the chipset).
Processors
The X6DHP-8G/X6DHP-8G2 supports single or dual 604-pin Intel Xeon EM64T
type processors at a FSB speed of 800 MHz. Please refer to the
serverboard description pages on our web site for a complete listing of
supported processors (www.supermicro.com).
Memory
The X6DHP-8G has six 184-pin DIMM sockets that can support up to 12 GB
of registered ECC DDR333 (PC2700) or up to 24 GB of registered ECC
DDR266 (PC2100) SDRAM. The X6DHP-8G2 has eight 240-pin DIMM sockets
that can support up to 16 GB of DDR2-400 SDRAM. Both serverboards
employ an interleaved configuration, which requires modules of the same
size and speed to be installed in pairs. Please refer to Chapter 5 for
memory speed jumper settings.
Onboard SCSI
SCSI is provided with an Adaptec AIC-7902 SCSI chip, which supports dual
channel Ultra320 SCSI at a throughput of 320 MB/sec (each channel). The
X6DHP-8G/X6DHP-8G2 provides two LVD Ultra320 SCSI ports.
Onboard Controllers/Ports
One floppy drive controller and two ATA/100 controllers are provided to
support up to four IDE hard drives or ATAPI devices. The color-coded I/O
ports include one COM port, a VGA (monitor) port, two USB 2.0 ports, PS/
2 mouse and keyboard ports and two gigabit Ethernet ports. (The rear COM
port is available with the use of a COM port kit (included with the system).
COM1 and COM2 are both headers on the X6DHP-8G/X6DHP-8G2.
z
1U passive heatsink (SNK-P0009, optional)
z One (1) CD containing drivers and utilities
z SuperServer 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual