Warning – SUPER MICRO Computer SUPERSERVER 6014P-8R User Manual

Page 37

Advertising
background image

Chapter 5: Advanced Serverboard Setup

5-3

Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed

Warning!

Make sure you lift the lever completely when

installing the CPU. If the lever is only partly raised, damage

to the socket or CPU may result.

!

Lever

With processor installed

Triangle (pin 1)

Empty socket

Triangle locating pin 1

Heatsink Installation

1. Do not apply any thermal compound to the heatsink or the CPU die; the

required amount has already been applied.

2. Place the heatsink on top of the CPU so that the four mounting holes are

aligned with those on the retention mechanism.

3. Screw in two diagonal screws until snug (do not fully tighten the screws

to avoid possible damage to the CPU). Then screw in the other two diago-

nal screws until snug. See Figure 5-2.

4. Finish the installation by fully tightening all four screws.

Note: refer to page 7-16 for a BIOS setting that determines fan speed.

*The heatsink (SNK-P0009) is an optional item that is sold separately.

Advertising
This manual is related to the following products: