SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 35)

Chapter 5: Advanced Serverboard Setup
5-1
Chapter 5
Advanced Serverboard Setup
This chapter covers the steps required to install processors, memory and
heatsinks to the X6DHP-8G/X6DHP-8G2 serverboard, connect the data and
power cables and install add-on cards. All serverboard jumpers and con-
nections are described and a layout and quick reference chart are included
in this chapter. Remember to close the chassis completely when you have
finished working on the serverboard to protect and cool the system.
5-1 Handling the Serverboard
Static electrical discharge can damage electronic components. To prevent
damage to printed circuit boards, it is important to handle them very care-
fully (see Chapter 4). Also note that the size and weight of the serverboard
can cause it to bend if handled improperly, which may result in damage. To
prevent the serverboard from bending, keep one hand under the center of
the board to support it when handling. The following measures are gener-
ally sufficient to protect your equipment from static discharge.
Precautions
• Use a grounded wrist strap designed to prevent static discharge.
• Touch a grounded metal object before removing any board from its anti-
static bag.
• Handle a board by its edges only; do not touch its components, periph-
eral chips, memory modules or gold contacts.
• When handling chips or modules, avoid touching their pins.
• Put the serverboard, add-on cards and peripherals back into their anti-
static bags when not in use.
Unpacking
The serverboard is shipped in antistatic packaging to avoid static damage.
When unpacking the board, make sure the person handling it is static pro-
tected.