2 how to reset the sp, 1 before you begin, 2 what to do – Sun Microsystems Sun Fire X4200 User Manual
Page 111: How to reset the sp, Before you begin, What to do
Chapter 9
System Monitoring and Maintenance Using the SP GUI
9-5
Note –
If you choose to cancel the firmware upgrade operation, the service
processor will reboot without the updated software. You must close the Internet
browser and log back in to the service processor web GUI before you can perform
any other type of operation.
If you clicked Start Update, a progress screen indicates that the firmware image is
being upgraded. Once the upgrade progress reaches 100%, the firmware upgrade is
complete.
After the upgrade operation has completed successfully, the service processor will
automatically reboot. This is done so that the image upgrade can take effect. You
cannot perform any other operation within your current Internet browser session.
9. Close your Internet browser and reconnect to the service processor.
Note –
If the configuration is not preserved, you should enter BIOS setup and save
the optimal default settings.
9.2
How to Reset the SP
This section explains how to reset the ILOM Service Processor.
9.2.1
Before You Begin
Log in to the service processor (SP) as Administrator or Operator to reach the ILOM
web GUI.
9.2.2
What to Do
1. From the Maintenance tab, choose Reset SP.