Sun Microsystems Sun Fire X4200 - Manual (Page 95)

Chapter 7 Command Line Interface Tasks 7-19
7.11.2.1 Syntax
set target [propertyname=value]
7.11.2.2 Targets, Properties, and Values
These targets, properties, and values are valid for NTP servers.
7.11.2.3 Example
To configure your service processor clock to synchronize with an NTP server, type:
set /SP/clients/ntp/server/1 address=125.128.84.20
Then enable the NTP service by typing:
set /SP/clock/usentpserver=enabled
Note – Once you enable the NTP service, it can take up to five minutes for the
service processor clock to synchronize.
7.12 How to Display Information About the
Service Processor
You can display active session, current versions, and other information about the
service processor using the command-line.
Target Property Value Default
/SP/clients/ntp/server/1 address <ipaddress> (none)
/SP/clients/ntp/server/2 address <ipaddress> (none)