Sun Microsystems Sun Fire X4200 - Manual (Page 152)

11-8 Sun Fire X4100 and Sun Fire X4200 Servers System Management Guide • December 2005
2. Complete the information in the Network Settings page.
Use the descriptions in TABLE 11-1 when completing the information.
3. Click Save for your settings to take effect.
Settings are considered "pending" until you click Save. Changing the IP address will
end your SP session.
You are prompted to close your Internet browser.
4. Log back in to the service processor using the new IP address.
If you changed the network settings, you must log back in to the service processor
with a new browser session.
11.5 How to Upload a New SSL Certificate
This section explains how to upload a Secure Sockets Layer (SSL) certificate and SSL
private key to use when accessing the ILOM Service Processor.
TABLE 11-1 Network Settings Page Fields
Item Description
MAC Address The service processor’s media access control (MAC) address is
factory-set. The MAC address is a hardware address that is unique
to each networked device. The service processor’s MAC address is
provided on a label on the SP, on the Customer Information Sheet
included on the ship kit, and in the BIOS Setup screen.
Configuration
Method Click one of these radio buttons to configure the service processor’s
IP address either dynamically or statically.
• Obtain an IP Address Automatically (Use DHCP) - Enables a
DHCP server to configure the service processor’s IP address
dynamically.
• Use the Following IP Address - Enables you to configure the
service processor’s IP address with a static IP. The IP Address,
Subnet Mask, and Default Gateway fields will become editable
when you select this option.
IP Address Set the service processor’s IP address. The IP address is a unique
name that identifies the system on a TCP/IP network.
Subnet Mask Set the subnet mask of the network on which the service processor
resides.
Default Gateway Set the service processor’s gateway access address.