Speco Technologies SIPT5 User Manual
Page 33
2-29
RTP B2 Frame
Enable
Checkbox to enable the B2 frame in RTP streaming
Audio
Select enable or disable the audio function.
Input Sensitivity
Select HIGH or LOW of the audio input sensitivity
Multicast IP
Select the multicast IP. Default settings is 228.5.6.1
Multicast TTL
Select the multicast TTL. Default setting is 255.
IGMP
Select video type connected to the video-in of this IP
device. If you use an incorrect video type, some images
might be lost.
Resolution
Select the video resolution of the IP device.
Frame rate mode
Select the frame rate mode.
Constant: The streaming’s frame rate remains
constant at all conditions.
Variable: The streaming’s frame rate will variants
according to the images variability to keep the
image quality good.
Frame rate
Select the frame rate of the video streaming.
Encoder Type
Select the encoder’s compression type.
1. MPEG4
2. MJPEG
Video Bitrate
Mode
Select the video bitrate mode.
Constant Bit Rate: The streaming’s bitrate remains
constant at all conditions.
Variable Bit Rate: The streaming’s bitrate will
variants according to the images variability to keep the
image quality good.
Video Maximum
Bitrate
Select the Maximum bitrate of the video straming.
Designating a limited bit rate may reduce frame
rate. Doing so will also disable Bit Rate setting below.
Bitrate
Select the bit rate of the video streaming. You can select
from 28Kbps to 3Mbps.
Note: Lower bit rate consumes less bandwidth but
delivers lower quality images.
High bit rate consumes more bandwidth but delivers
higher quality images.
Serial Port Baud
Rate
Select the Baud Rate setting of serial port.
Serial Port Control Select the Control setting of serial port.
RTSP port
Select the port for this IP device to support RTSP
Video RTP Over
Multicast
Enable/disable the multicast video streaming via RTP
protocol
Audio RTP Over
Multicast
Enable/disable the multicast audio streaming via RTP
protocol
Video control port
Select the port for this IP device to support video control
function of the application program.
Video streaming
port (TCP Only)
Select the port for this IP device to support video
streaming function of the application program.
Video multicast
port (Multicast
Select the port for this IP device to support video multicast
function of the application program.