Kathrein MSK 25 - Manual (Page 44)

Spectrum Measurement
44
Spectrum Measurement
The frequency spectrum in the SAT, TV and FM modes may be displayed
on the TFT screen for evaluation purposes.
You can call up the function ‚spectrum measurement‘ in each particular
mode (SAT, TV, FM).
Command for ‚spectrum measurement‘: [2ndF] [Spect].
Back to the regular LC display: 2 x [2ndF].
By pressing [-] and [+], you can move a cursor ▽ on the level curve in
order to measure certain level minima and level maxima. The frequency
and the value measured are displayed in the top row of the screen. The
measurement range is displayed in dBµV on the ordinate on the left hand
side of the screen. The level measurement range is set automatically.
The level peak value is measured in the spectrum analysis.
SAT Spectrum
In SAT mode (see corresponding chapter), the entire SAT spectrum from
920 MHz...…2150 MHz can be displayed.
LC display
TV Spectrum
The TV mode (see corresponding chapter) is divided into four ranges
which can be selected by pressing either [1], [2], [3] or [4] , see screen
as well as explanation shown below.
Example for UHF
SAT-Full