KTM Supermoto 690 - Manual (Page 86)

MAINTENANCE WORK ON CHASSIS AND ENGINE
84
100146-10
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Remove the bushing b  . Clean and grease the roll surfaces of the bushing and the shaft
seal ring b  .
Long-life grease ( P. 155)
ದ Clean and grease the thread of the wheel spindle and nut b  .
Long-life grease ( P. 155)
ದ Clean the fixing locations on the brake caliper support and swingarm.
ದ Mount the rubber damper and rear sprocket carrier in the rear wheel.
ದ Stand the rear wheel in the swingarm and mount the brake caliper on the brake disc.
100147-10
ದ Push the brake caliper support and the swingarm b into the fixing location. Lay the
chain on the rear sprocket and fit the wheel spindle.
Info
Fit the chain left and right adjusters b  in similar positions.
ದ Push the rear whell forwards so that the chain adjusters are located on the adjusting
screws, and tighten nut
b  .
Specification
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
b  .
Nut, rear wheel spindle M25x1.5 90 bNm (66.4blbfbft)
ದ Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a tight spot.
ದ Taking rear from work stand. ( P. 57)