Kathrein UFC 861si - Manual (Page 14)

14
Use the
 
buttons here to select the settings for your TV set.
Refer to the operating instructions for your television set!
Video Output
Here select the type of video signal at the Scart socket or HDMI socket. Select the signal that your TV set
can process.
- FBAS – Composite baseband signal
(colour/picture/blanking/synchronous
signal)
- RGB – Red/Green/Blue signal
- YUV – Component signal
- Y/C – S-Video signal (luminance/chrominance) or
TV aspect ratio
Here select the TV picture format. Either
- 4:3 or
- 16:9
Display Format
Select the screen display mode here:
- for TV type “4:3”: “Pan & Scan” or “Letter-Box”
- for TV type “16:9”: “Automatic” or “Always 16:9”
Rear fan
Here you can select whether the rear fan always runs whilst the unit is switched on “On” or whether the fan
will be switched on and off again at pre-programmed intervals “Scheduled”.
FIRST INSTALLATION
The following display appears: