Kathrein UFC 861si - Manual (Page 63)

63
You can programme a recording from the various views of the EPG (“Current”, “Programme list”, “Highlights”
and “Detailed information”) and from within their various sub-menus. When programming recordings, the
EPG automatically adapts to the actual SAT IF input signal mode (Single Mode/Loop Through/Double
Tuner). Example: If you are operating the UFC 861 in loop-through mode, you cannot simultaneously record
one programme on the ARD channel and one on the ProSieben channel, because the two channels are not
transmitted on the same transponder.
Use the cursor buttons (
 
) to select the programme you want and press the

(red) button.
The following display appears (example):
If there are no EPG data
available for the channel
you selected:
Select the channel for
which you want to programme a
recording in the “Current” view and
press the

(red) button. As there
is no EPG data, you must enter the
data (date, start, end) manually. Enter
the data using the cursor buttons (
 
) and numeric pad. Press the button to save your
settings.
You can set the automatic lead-in and
run-on times for your recordings in the
“User Settings”, “EPG Settings” menu
(see also the Chapters “User Settings”,
“EPG Settings”)
PROGRAMMING A RECORDING
You now have a number of options to programme your recording. The settings are made using the cursor
buttons (
 
) and the numeric pad:
If a program on a protected channel is selected, you must enter the four-digit PIN
code (factory setting “0000”). The PIN can be changed by the user, as described in
the Chapter “Access control”.
ELECTRONIC PROGRAMME GUIDE (EPG)