Kathrein UFC 861si - Manual (Page 46)

46
USER SETTINGS
Use the

buttons here to select the standard recording time. If you forget to stop a recording you
started manually, it is automatically stopped by the receiver when the standard recording time elapses.
You can choose between 30 minutes and 4 hours, in 30 minute increments.
STANDARD RECORDING TIME
When you have made all the settings, press the button to save them.
SAVE
EPG SETTING
Here use the

buttons to select the number of minutes before the time set in the EPG at which the
recording should start. You can choose a value between 1 minute and 10 minutes, in 1 minute increments.
The recording will start that number of minutes before the due time. This allows a contingency for small
variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the
Chapter “Recording List” under “Edit Recordings”, “Cut”.
LEAD-IN TIME FOR RECORDING
Here use the

buttons to select the number of minutes after the time set in the EPG for which the
recording should run on. You can choose a value between 1 minute and 30 minutes, in 1 minute increments.
The recording will stop that number of minutes after the due time. This allows a contingency for small
variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the
Chapter “Recording List” under “Edit Recordings”, “Cut”.
RUN-ON TIME FOR RECORDING
DYNAMIC SI HANDLING
Use the

buttons to select “On” or “Off”. When the receiver is switched on, it automatically uses the
program names broadcast by the transmitter. Setting this to “Off” allows you to change the program names,
and prevents the receiver automatically changing those names back to the broadcast setting.